07

2020

-

11

Water curtain machine installation matters 1. The water curtain machine should be installed on a flat ground. The horizontal error at the left and right ends of the water tank should be within ± 2mm, and the horizontal error before and after should be within ± 5mm. 2. Add 250 clean water to the water tank (about the 2/3 of the water tank).

Source:


Installation matters of water curtain machine 1. The water curtain machine should be installed on a flat ground, the horizontal error of the left and right ends of the sink should be within ± 2mm, and the front and rear horizontal error should be within ± 5mm 2. Add 250 clean water to the sink (about 2/3 of the sink).

Installation matters of water curtain machine

1.The water curtain machine should be installed on a flat ground, and the horizontal error at the left and right ends of the sink should be within ±2mmWithin, the horizontal error before and after should be.5mmWithin

2.Add to the sink (about 2/3 of the sink)250 cleanClear water.

3.Power supply system: The power supply system adopts three-phase four-wire system. The housing of the power supply equipment should be connected to the power supply system and repeatedly grounded. Grounding resistance less10Ω 。

4.Turn on the water pump (pay attention to the direction of rotation) to adjust the flow rate, and then fine-tune the water curtain to form a uniform water curtain. If the water curtain cannot form a uniform water film, you can scrub the water curtain with detergent to remove grease on the surface of the water curtain, and the floor is not flat. Tilting the body can also cause uneven flow of the water curtain, so troubleshooting should be eliminated when installing a specific location. If the flow of the water curtain is uneven, the flow can be adjusted according to the valve on the side of the water curtain machine.

5.In order to prevent the paint from adhering to the side panels of the spray booth and difficult to clean after curing, apply a small amount of butter and stick a plastic film on the side panels to facilitate future cleaning. You can also apply a small amount of butter on the fan blades of the fan, which will also be convenient for cleaning in the future.

6.When the workpiece travels to the middle of the spraying room for spraying, please use the water curtain machine to turn on the fan (pay attention to the direction of rotation to prevent the fan from reversing).

maintenance of water curtain machine:

1.In order to facilitate the separation of paint residues and water from the painting operation in the water curtain machine sink, an appropriate amount of flocculant can be added to the sink to coalesce the paint residues and facilitate removal .

2.After each shift, the paint residue and filter should be cleaned in time.

3.When the water level of the sink is lower than the lower limit, please replenish water in time. However, the upper limit cannot be exceeded.

4.Regularly clean the side panels of the spray booth, the paint mist separation chamber, the inner wall of the pipe and the combustibles on the fan blades to ensure smooth airflow and prevent fire.